DocumentCode :
2822799
Title :
Developing a Multi-node Calibration System for CAN Bus Based Vehicle
Author :
Yang, ShiWei ; Yang, Lin ; Zhuo, Bin
Author_Institution :
Shanghai Jiao Tong Univ., Shanghai
fYear :
2006
fDate :
13-15 Dec. 2006
Firstpage :
199
Lastpage :
203
Abstract :
Calibration is an important step in the development of the vehicle electronic control unit (ECU). After a successful design of the interface between TouCAN module and CAN bus and bit timing, master device may multi connect to slave nodes by broadcasting protocol commands to more than one slave node, we developed a multi-node calibration system for multi-ECU used vehicle based on CCP protocol. It was realized via reasonable configuration of identifiers of message buffers, message filter registers and bit timing. This calibration system provides an effective method to calibrate multi ECUs simultaneously and can help to match the parameters of different ECUs better.
Keywords :
automotive electronics; calibration; controller area networks; field buses; protocols; system buses; CAN bus-based vehicle; TouCAN module; bit timing; broadcasting protocol; master device; message buffers; message filter registers; multinode calibration system; slave nodes; vehicle electronic control unit; Automobiles; Broadcasting; Calibration; Control systems; Fuels; Master-slave; Mechanical engineering; Protocols; Timing; Vehicles; Bit timing; CAN; CCP; Calibration; Node; Vehicle;
fLanguage :
English
Publisher :
ieee
Conference_Titel :
Vehicular Electronics and Safety, 2006. ICVES 2006. IEEE International Conference on
Conference_Location :
Beijing
Print_ISBN :
1-4244-0759-1
Electronic_ISBN :
1-4244-0759-1
Type :
conf
DOI :
10.1109/ICVES.2006.371582
Filename :
4234018
Link To Document :
بازگشت