DocumentCode :
2848926
Title :
Low power eeprom designed for sensor interface circuit
Author :
Xiangyun, Meng ; Sen, Yang ; Zhongjian, Chen ; Wengao, Lu ; Yacong, Zhang ; Jingqing, Huang ; Haojiong, Li ; Weiguo, Su ; Song, Li
Author_Institution :
Dept. of Microelectron., Peking Univ., Beijing, China
fYear :
2011
fDate :
17-18 Nov. 2011
Firstpage :
1
Lastpage :
2
Abstract :
A new low-power EEPROM circuit for sensor interface circuit is introduced in this paper. The calibration data and parameter setting data stored in EEPROM can be reloaded automatically by the power-on-reset (POR) technique when the power is on. The module only consumes power during power-on-reset and data changing by status optimization and low-power design. This EEPROM circuit design has been used in a MEMS accelerometer readout circuit verified by 0.35μm CMOS EEPROM process. The results are satisfying in that the module can write and store 25bit data and automatically reloads data within 0.1μs after power-on and then turns to low power mode.
Keywords :
CMOS integrated circuits; EPROM; accelerometers; calibration; integrated circuit design; low-power electronics; readout electronics; sensors; CMOS EEPROM process; EEPROM circuit design; MEMS accelerometer readout circuit; calibration data; low power mode; low-power design; parameter setting data; power-on-reset technique; sensor interface circuit; size 0.35 mum; status optimization; time 0.1 mus; word length 25 bit; Accelerometers; Calibration; Computer architecture; EPROM; Micromechanical devices; Microprocessors; Threshold voltage; EEPROM; Low Power; accelerometer; readout circuit;
fLanguage :
English
Publisher :
ieee
Conference_Titel :
Electron Devices and Solid-State Circuits (EDSSC), 2011 International Conference of
Conference_Location :
Tianjin
ISSN :
Pending
Print_ISBN :
978-1-4577-1998-1
Electronic_ISBN :
Pending
Type :
conf
DOI :
10.1109/EDSSC.2011.6117576
Filename :
6117576
Link To Document :
بازگشت