• DocumentCode
    2854203
  • Title

    A Product Design Using an S-Shaped and C-Shaped Transition Curves

  • Author

    Yahaya, S.H. ; Ali, Jamaludin Md ; Fauadi, Muhammad Hafidz Fazli Md

  • Author_Institution
    Fac. of Manuf. Eng., UTeM, Durian Tunggal
  • fYear
    2008
  • fDate
    26-28 Aug. 2008
  • Firstpage
    149
  • Lastpage
    153
  • Abstract
    This paper proposes a design technique using an S-shaped and C-shaped transition curves. A simple algorithm will be proposed in this paper where this algorithm will be based on Habib and Sakai [1]. In order to use this algorithm, a few constraints are considered such as the continuity, control points, curvature, radius etc. In this paper, we will apply this algorithm to design a spur gear tooth and vase in the two and three dimensional. The function involved is Bezier like cubic function with the smoothness is G2 continuity.
  • Keywords
    software engineering; Bezier like cubic function; product design; shaped transition curves; spur gear tooth; transition curves; Algorithm design and analysis; Computer aided manufacturing; Computer graphics; Design engineering; Gears; Product design; Pulp manufacturing; Spirals; Teeth; Visualization; Bézier Like Cubic; Curvature; Spur Gear Tooth; Vase;
  • fLanguage
    English
  • Publisher
    ieee
  • Conference_Titel
    Computer Graphics, Imaging and Visualisation, 2008. CGIV '08. Fifth International Conference on
  • Conference_Location
    Penang
  • Print_ISBN
    978-0-7695-3359-9
  • Type

    conf

  • DOI
    10.1109/CGIV.2008.39
  • Filename
    4626999
    • Link To Document
    https://search.isc.ac/dl/search/defaultta.aspx?DTC=49&DC=2854203