Fabrication status of acs accelerating modules of J-PARC LINAC

Author

Ao, H. ; Hirano, Keizo ; Ueno, Atsushi ; Morishita, Takahiro ; Hasegawa, Kiyotomo ; Yamazaki, Yasuyuki ; Ikegami, M.

Author_Institution

JAEA, Tokai

fYear

2007

fDate

25-29 June 2007

Firstpage

1514

Lastpage

1516

Abstract

We have been fabricated the several ACS modules step by step: the first buncher, the second buncher, the low-beta accelerating module, and so on. This paper reports the improvement of the frequency and summarizes these RF measurement results. The data of the frequency fluctuation from brazing or stacking have been accumulated, and then the second buncher could be tuned correctly, although the frequency of the first buncher was lower than the target design. In the present fabrication process, about 0.1 to 0.2 MHz fluctuation should be corrected at each measurement step. As the result, the frequency could be tuned to the range of the movable tuner.

Keywords

accelerator RF systems; ion accelerators; ion beams; linear accelerators; particle beam bunching; ACS accelerating modules; H^- beam; J-PARC linac; RF measurement; brazing; buncher module; frequency 0.1 MHz to 0.2 MHz; frequency fluctuation; stacking; Acceleration; Bridges; Fabrication; Fluctuations; Linear particle accelerator; Particle beams; Radio frequency; Stacking; Tuners; Tuning;

fLanguage

English

Publisher

ieee

Conference_Titel

Particle Accelerator Conference, 2007. PAC. IEEE

Conference_Location

Albuquerque, NM

Print_ISBN

978-1-4244-0916-7

Type

conf

DOI

10.1109/PAC.2007.4440807

Filename

4440807