DocumentCode :
2948519
Title :
Strontium titanate DC electric field switchable and tunable bulk acoustic wave solidly mounted resonator
Author :
Saddik, George N. ; Boesch, Damien S. ; Stemmer, Susanne ; York, Robert A.
Author_Institution :
Department of Electrical and Computer Engineering, University of California Santa Barbara, 93106, USA
fYear :
2008
fDate :
15-20 June 2008
Firstpage :
1263
Lastpage :
1266
Abstract :
A voltage switchable/tunable strontium titanate solidly mounted BAW resonator was implemented using an acoustical Bragg reflector of alternating high and low acoustic impedance layers. In the absence of any bias the device is merely capacitive, but under a DC bias the material becomes piezoelectrically active, leading to a BAW resonance that is effectively turned on and off by the applied field. In the resonant state a voltage-dependent frequency trimming of 1 % is observed, from 7.05 GHz to 6.98 GHz with an applied bias of 0–9 V, respectively. The quality factor at the resonant frequency was approximately 100, limited by the simplicity of the device design. The Q was relatively constant with applied bias, with an effective electromechanical coupling coefficient that varied linearly with applied bias up to a maximum of 3.3 %.
Keywords :
Acoustic devices; Acoustic waves; Frequency; Impedance; Piezoelectric materials; Q factor; Resonance; Strontium; Titanium compounds; Voltage; Acoustic resonators; bulk acoustic wave devices; delay filters; ferroelectric films; piezoelectric resonators;
fLanguage :
English
Publisher :
ieee
Conference_Titel :
Microwave Symposium Digest, 2008 IEEE MTT-S International
Conference_Location :
Atlanta, GA, USA
ISSN :
0149-645X
Print_ISBN :
978-1-4244-1780-3
Electronic_ISBN :
0149-645X
Type :
conf
DOI :
10.1109/MWSYM.2008.4633289
Filename :
4633289
Link To Document :
بازگشت