Failure Analysis of Pitting Problem on Microchip Al Bondpads in Wafer Fabrication

A bond pad failure mechanism of galvanic corrosion was studied. Analysis results showed that over-etch process, EKC and DI water over cleaning revealed more pitting with Cu seed due to galvanic corrosion. To control and eliminate galvanic corrosion, the etch recipe was optimized and etch time was reduced about 15% to prevent damaging the native oxide. EKC cleaning time was remaining unchanged in order to maintain bond pad F level at minimum level. In this study, the PRS process was also optimized and CF4 gas ratio was reduced about 45%. Moreover, 02 process was added after PRS process so as to increase the native oxide layer on Al bondpads to prevent galvanic corrosion.