DocumentCode
3147807
Title
An adaptive control for DC-to-DC converters
Author
Tse, C.K. ; Adams, K.M.
Author_Institution
Dept. of Electr. & Electron. Eng., Melbourne Univ., Parkville, Vic., Australia
fYear
1990
fDate
0-0 1990
Firstpage
213
Lastpage
218
Abstract
A simple adaptive control strategy is proposed for regulating the output voltage of a DC-to-DC converter operating in continuous mode. The algorithm is derived by perturbing an approximate large-signal equation around a ´varying´ operating point. This differs from the usual practice of applying the perturbation technique around a fixed operating condition. In the algorithm, the control equation as well as the control parameter is constantly adjusted according to the environmental changes to meet the specified dynamical requirement. Simulation results are presented.<>
Keywords
adaptive control; power convertors; DC-to-DC converters; adaptive control; continuous mode; perturbation technique; Adaptive control; DC-DC power converters; Equations; Feedback; Matrix converters; Steady-state; Switching circuits; Vectors; Virtual colonoscopy; Voltage;
fLanguage
English
Publisher
ieee
Conference_Titel
Power Electronics Specialists Conference, 1990. PESC '90 Record., 21st Annual IEEE
Conference_Location
San Antonio, TX, USA
Type
conf
DOI
10.1109/PESC.1990.131191
Filename
131191
Link To Document