Abrasive water-jet process control overvie

Author

Wang, Weizhang ; Wang, Mingbo

Author_Institution

Dept. of Mech. & Electr. Eng., Weifang Univ., Weifang, China

fYear

2011

fDate

16-18 April 2011

Firstpage

66

Lastpage

69

Abstract

Current research and developments of the abrasive water jet process control were reviewed in this paper. The methods used to monitor the abrasive particles suction process, the water orifice condition, the focus tube condition and wear were reviewed and their advantages and disadvantages were also analyzed, respectively. The expert system with neutral network method was suggested to monitor more than one cutting parameter in order to optimize the cutting process.

Keywords

abrasion; expert systems; orifices (mechanical); process control; process monitoring; water jet cutting; abrasive particle suction process; abrasive water jet process control; cutting parameter; cutting process optimization; expert system; focus tube condition; neutral network method; water orifice condition; wear; Abrasives; Acoustics; Electron tubes; Monitoring; Orifices; Process control; Water jet cutting; abrasive water jet; acoustic sensing; neutral network method; process control;

fLanguage

English

Publisher

ieee

Conference_Titel

Consumer Electronics, Communications and Networks (CECNet), 2011 International Conference on

Conference_Location

XianNing

Print_ISBN

978-1-61284-458-9

Type

conf

DOI

10.1109/CECNET.2011.5769009

Filename

5769009