DocumentCode
3164779
Title
Notice of Retraction
Experimental study on Ti-alloy machined by EDM
Author
Wei Zhao ; HongGang Zhu ; JieChao Jiang
Author_Institution
Sch. of Automobile, Chang´an Univ., Xi´an, China
fYear
2011
fDate
8-10 Aug. 2011
Firstpage
3973
Lastpage
3975
Abstract
Notice of Retraction
After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.
We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.
The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.
In this paper, research is taken on alloy TC4 machined by EDM using graphite electrode. It is thought that positive polarity machining should be taken no matter big or small the pulse width will be used. The reason of no carbon-protection-film on the surface of the TC4 after EDM is analyzed carefully by the way of scan electron microscope and X-radial diffraction.
After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.
We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.
The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.
In this paper, research is taken on alloy TC4 machined by EDM using graphite electrode. It is thought that positive polarity machining should be taken no matter big or small the pulse width will be used. The reason of no carbon-protection-film on the surface of the TC4 after EDM is analyzed carefully by the way of scan electron microscope and X-radial diffraction.
Keywords
X-ray diffraction; electrical discharge machining; electrodes; scanning electron microscopy; titanium alloys; EDM; TC4 titanium alloy; X-ray diffraction; electrical discharge machining; graphite electrode; no-carbon-protection-film; positive polarity machining; scanning electron microscopy; Carbon; Copper; Machining; Titanium alloys; Ti-alloy carbon-protection-film; electrical discharge machining (EDM);
fLanguage
English
Publisher
ieee
Conference_Titel
Artificial Intelligence, Management Science and Electronic Commerce (AIMSEC), 2011 2nd International Conference on
Conference_Location
Dengleng
Print_ISBN
978-1-4577-0535-9
Type
conf
DOI
10.1109/AIMSEC.2011.6010133
Filename
6010133
Link To Document