Notice of RetractionOptimization Model of Injection Gate Location Based on Empirical Method

Notice of Retraction

After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.

We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.

The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.

Aiming at the importance of gate location in the injection molding design, this article, which focuses on thin-wall plastic part, is aware that warpage is the primary deformity of thin-wall plastic part, treats the objective function, design factor and restricted function in gate location optimization method, and builds the mathematics model based on the empirical method for the gate location optimization. The analysis and verification by adopting the software Moldflow, prove that the optimization mathematics model which gives basis for rapid and accurate simulation analysis and numerical calculating, is effective.