Requirements for an interface between a plug-in vehicle and an energy system

Author

Rautiainen, A. ; Evens, C. ; Repo, Sami ; Jarventausta, Pertti

Author_Institution

Dept. of Electr. Energy Eng., Tampere Univ. of Technol., Tampere, Finland

fYear

2011

fDate

19-23 June 2011

Firstpage

1

Lastpage

8

Abstract

In this paper, requirements for an interface between a plug-in vehicle and an energy management system are discussed. A case where there is a service provider aggregating large amount of small resources was considered. Requirements were set for electrical and ICT interfaces and some related standardization work was briefly presented. Four different types of interfaces were presented: passive load (type 1), dynamic load (type 2), V2G (vehicle-to-grid - type 3) and V2H (vehicle-to-home - type 4).

Keywords

battery management systems; battery powered vehicles; energy management systems; ICT interfaces; V2G; V2H; dynamic load; electrical interfaces; energy management system; passive load; plug-in vehicle; service provider; small resource aggregation; vehicle- to-home; vehicle-to-grid; Batteries; Electricity; Electricity supply industry; Frequency control; IEC standards; Power systems; Vehicles; ICT; Plug-in hybrid electric vehicle; electric vehicle; electricity network; interface; power system;

fLanguage

English

Publisher

ieee

Conference_Titel

PowerTech, 2011 IEEE Trondheim

Conference_Location

Trondheim

Print_ISBN

978-1-4244-8419-5

Electronic_ISBN

978-1-4244-8417-1

Type

conf

DOI

10.1109/PTC.2011.6019461

Filename

6019461