Factors influencing time resolution of scintillators and ways to improve them

The renewal of interest in Time of Flight Positron Emission Tomography (TOF-PET), as well as the necessity to precisely tag events in high energy physics (HEP) experiments at future colliders are pushing for an optimization of all factors affecting the time resolution of the whole acquisition chain comprising the crystal, the photo detector, and the electronics. The time resolution of a scintillator-based detection system is determined by the rate of photoelectrons at the detection threshold, which depends on the time distribution of photons being converted in the photo detector. The possibility to achieve time resolution of about 100ps FWHM requires an optimization of the light production in the scintillator, the light transport and its transfer from the scintillator to the photo detector. In order to maximize the light yield, and in particular the density of photons in the first nanosecond, while minimizing the rise time and decay time, particular attention must be paid to the energy transfer mechanisms to the activator as well as to the energy transition type at the activator ion. Alternatively other light emission mechanisms can be considered. We will show that particularly Cerenkov emission can be used for this purpose. Special emphasis was put on the light transport within the crystal and at its interface with the photo detector. Since light is produced isotropically in the scintillator the detector geometry must be optimized to decrease the optical path-length to the photo detector. Moreover light bouncing within the scintillator, affecting about 70% of the photons generated in currently used crystals, must be reduced as much as possible. We also investigate photonics crystals that are specifically designed to favor specific light propagation modes at the limit of total reflection inside and outside of the crystal, and how they might increase the light transfer efficiency to the photo detector and hence improve time resolution. Examples for the production and- - deposition of photonics crystals as layers on LYSO and LuYAP crystals are shown here, as well as first results on an improved light extraction due to this method.