DocumentCode :
3357871
Title :
Transfer of the induction motor to the UPS system after power failure
Author :
Sürgevil, T. ; Akpinar, E.
Author_Institution :
Dept. of Electr. & Electron. Eng., Dokuz Eylul Univ., Izmir
fYear :
2007
fDate :
10-12 Sept. 2007
Firstpage :
621
Lastpage :
628
Abstract :
The stator current and electromagnetic torque transients of induction motor have been investigated in this paper, when the motor is transferred to uninterruptible power supply (UPS). The motor is directly fed by the infinite bus before the power outage, then it is transferred to the UPS system, which consists of two cascaded 3-phase pulse width modulated converters. Both converters are controlled by a single fixed-point digital signal processor (DSP). The computer simulation results of the UPS and motor are obtained from Matlab Simulink models and these results are compared to the experimental ones.
Keywords :
induction motors; uninterruptible power supplies; UPS system; electromagnetic torque transients; induction motor; power failure; single fixed-point digital signal processor; stator current; uninterruptible power supply; Digital signal processors; Electromagnetic induction; Electromagnetic transients; Induction motors; Pulse width modulation; Pulse width modulation converters; Pulsed power supplies; Stators; Torque; Uninterruptible power systems;
fLanguage :
English
Publisher :
ieee
Conference_Titel :
Electrical Machines and Power Electronics, 2007. ACEMP '07. International Aegean Conference on
Conference_Location :
Bodrum
Print_ISBN :
978-1-4244-0890-0
Electronic_ISBN :
978-1-4244-0891-7
Type :
conf
DOI :
10.1109/ACEMP.2007.4510579
Filename :
4510579
Link To Document :
بازگشت