Experimental studies on gear-honing-tool with laser brazing film CBN

During the process of brazing cubic boron nitride (CBN) gear-honing-tool by Laser, cleaning of the gear-honing-tool and film plating CBN abrasive, and the thickness of brazing coating directly affect the quality and life of gear-honing-tool. In the paper, based on experiment the process of laser brazing CBN is summed up, the thickness interrelationship of brazing filler metal from beginning to end is obtained, the rule of laser facula´s moving speed is studied on solder layer thickness and the radial change of gear tooth thickness. It is shown that the bonding among CBN, gear-honing-tool and solder can be realized by laser brazing. In order to improve quality of brazing, the moving speed of laser facula must be reduced along radial direction of gear honing tool. As to different size of CBN abrasive, the thickness of solder layer should be varied so that the bare rates of cutting edge can be ensured. The solder layer thickness should be controlled between 1.25 and 1.5 times of average size of abrasive grains. The thickness of solder layer depends on laser energy and soldering time that can be controlled by the moving speed of laser facula.