Comparing between three current source circuits for using in bio electrical impedance design

Author

Ar-Rawi, A.H. ; Moghavvemi, M. ; Wan-Ibrahim, W.M.A.

Author_Institution

Dept. of Electr. Eng., Univ. of Malaya, Kuala Lumpur, Malaysia

fYear

2009

fDate

14-15 Dec. 2009

Firstpage

1

Lastpage

4

Abstract

The current source circuit is one of the most important parts in the bioelectrical impedance devices and Bio Impedance tomography (BIT). There are many types of these circuits like (Howland, one op-amp, two op-amps, etc). In this study three types of electronic circuits are built and tested by using "Tina 7" simulation software from Texas Instrument (TI). THS4022 high speed Dual op-amps from Texas Instruments (TI) are used. The results showed that Howland circuit and one op-amp circuit are very stable up to the frequencies of 10 MHz, better than the two op-amp circuit. The two op-amp circuit is good for low frequencies with 10 KHz maximum frequency.

Keywords

bioelectric potentials; biomedical imaging; constant current sources; electric impedance imaging; operational amplifiers; tomography; Bio Impedance tomography; Howland circuit; Texas Instruments; Tina 7 simulation software; bioelectrical impedance design; current source circuits; one op-amp circuit; two op-amp circuit; Bioelectric phenomena; Circuit testing; Electronic circuits; Electronic equipment testing; Frequency; Impedance; Instruments; Operational amplifiers; Software testing; Tomography;

fLanguage

English

Publisher

ieee

Conference_Titel

Technical Postgraduates (TECHPOS), 2009 International Conference for

Conference_Location

Kuala Lumpur

Print_ISBN

978-1-4244-5223-1

Electronic_ISBN

978-1-4244-5224-8

Type

conf

DOI

10.1109/TECHPOS.2009.5412071

Filename

5412071