Impact of Ocean Wave Height on L-band Passive and Active Microwave Observation of Sea Surfaces

The impact of ocean waves on L-band brightness temperatures and backscatter from the ocean surface was analyzed using Aquarius data. Matchups of Aquarius data with significant wave height (SWH) from National Oceanic and Atmospheric Administration (NOAA) WaveWatch3 reanalysis and the ocean surface wind are generated. We perform the analysis using two different wind speed products: special sensor microwave imager/sounder (SSMI/S) and National Center for Environmental Prediction (NCEP) operational data. Interestingly, the influence of SWH manifests itself differently for these two wind speed products. Conditionally, averaged normalized radar cross-section ( ) and brightness temperatures ( ) by NCEP wind speed show strong influence by SWH over the entire range of NCEP wind speeds with a larger impact at lower wind speeds. However, performing the same analysis conditioned on the SSMI/S wind speed, the conclusion becomes entirely different: the SWH effects appear small at low wind speeds ( ) and increase with increasing wind speed. The apparent contradiction is a result of the differing characteristics of NCEP and SSMI/S wind speeds. NCEP wind is an atmospheric model estimate of surface wind velocity, whereas the SSMI/S wind is a microwave remote sensing product, representing the characteristics of sea surface roughness. The impact of SWH needs to be considered when the SSMI/S wind speed is assimilated into the numerical weather prediction models, such as the NCEP.