Notice of RetractionCorrection and data processing for tooth surface deviation of hypoid gear

Notice of Retraction

After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.

We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.

The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.

The correction and the data processing for tooth surface deviation of hypoid gear are a key link to the realization of the digitized closed loop manufacture. Based on one-dimensional probe, the method of error compensation for hypoid gears is studied. By means of the principle of the proportional correction of spiral bevel gears, the theory and the method of the automatic compensation and feedback correction to machine tool settings are investigated according to the measuring data. Without the human intervention, the correction of machine tool settings can be automatically completed. And 1 to 3 trial cuts, the tooth surface deviations can meet the design requirement. Finally, the correction of machine tool settings and the contact pattern test of tooth surfaces have been carried out. All these verify that the approaches of the correction and the data processing are feasible and accurate.