DocumentCode
530820
Title
Notice of Retraction
Fabrication of micro gear based on micro-milling
Author
Shi Wentian ; Liu Yude
Author_Institution
Coll. of Mech. Eng., Beijing Technol. & Bus. Univ., Beijing, China
Volume
2
fYear
2010
fDate
24-26 Aug. 2010
Firstpage
608
Lastpage
611
Abstract
Notice of Retraction
After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.
We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.
The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.
With the rapid development of micro-parts and MEMS, It is necessary to study the micro gear using different manufacturing technology. In this paper, it is described the fabrication of micro gear via micro model milling in the micro turn-milling NC machine. A micro gear with the module is 100μm and the thickness is 400μm is machined using the micro involute gear milling Cutter which is designed particularly. The experiment of micro-milling is executed by the two different method of milling, which is the conventional milling and climb milling, the vibration is detected and analyzed in order to chose the best milling method. The micro gear which teeth is 18 and 20 is processed in climb milling and assembled successfully eventually.
After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.
We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.
The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.
With the rapid development of micro-parts and MEMS, It is necessary to study the micro gear using different manufacturing technology. In this paper, it is described the fabrication of micro gear via micro model milling in the micro turn-milling NC machine. A micro gear with the module is 100μm and the thickness is 400μm is machined using the micro involute gear milling Cutter which is designed particularly. The experiment of micro-milling is executed by the two different method of milling, which is the conventional milling and climb milling, the vibration is detected and analyzed in order to chose the best milling method. The micro gear which teeth is 18 and 20 is processed in climb milling and assembled successfully eventually.
Keywords
gears; micromechanics; milling; numerical control; turning (machining); MEMS; NC machine; climb milling; micro gear; micro turn-milling; micro-milling; Gold; Milling; Teeth; micro gear; micro involute gear milling; micro milling;
fLanguage
English
Publisher
ieee
Conference_Titel
Computer, Mechatronics, Control and Electronic Engineering (CMCE), 2010 International Conference on
Conference_Location
Changchun
Print_ISBN
978-1-4244-7957-3
Type
conf
DOI
10.1109/CMCE.2010.5610417
Filename
5610417
Link To Document