Sensitive All-Optical Channel-Drop Sensor in Photonic Crystals

We report the results of a study of an optical sensor based on a channel-drop technique with two cascaded cavities in photonic-crystal slabs. Quality factors and intensities of the resonant modes of the sensor were analyzed with three-dimensional simulations. With the introduction of a reflector in the bus-channel and by control of the coupling between the two cavities and the drop-channel, the drop efficiency can be remarkably increased. In addition to the simulation, the two cavity sensor is fabricated and tested for optical response to water and oil infiltration. Both direct visual imaging and quantitative analysis were applied in experiment. A difference of refractive index Δn = 0.12 between water and oil samples results in a wavelength shift of 18.3 nm, which greatly matches the simulation result of 20 nm and indicates a sensitivity of 153 nm RIU^-1. Both resonant peaks for water and oil infiltration have good selectivity in their transmission spectrum. The contrast between the broadband output of the bus-channel and the highly wavelength-selective outputs of the drop-channel opens opportunities for the two cascaded-cavity system as a fundamental building block for a multiplex drop-channel array for all-optical sensing, which can be widely used for bio/chemical detection and environmental monitoring.