Comparison of sensitivity between UHF method and IEC 60270 for onsite calibration in various GIS

Author

Hoshino, Toshihiro ; Koyama, Hiroshi ; Maruyama, Shiro ; Hanai, Masahiro

Author_Institution

Toshiba Corp., Kanagawa

Volume

21

Issue

4

fYear

2006

Firstpage

1948

Lastpage

1953

Abstract

It is more important to obtain the sensitivity line, which is defined as a correlation between the ultra-high-frequency (UHF) signal (mV) and apparent charge (pC), for onsite calibration regarding partial discharge (PD). Synchronous measurement of the UHF method and IEC 60270 enables us to obtain the sensitivity line and to estimate the apparent charge in on-site substations. The sensitivity line of 3-phase gas-insulated switchgear (GIS) is compared to that of single-phase GIS, and differences in defects are also discussed. The fundamental data in this paper contribute to on-site insulation diagnosis of GIS

Keywords

calibration; gas insulated switchgear; partial discharges; GIS; IEC 60270; UHF method; apparent charge; gas-insulated switchgear; onsite calibration; onsite substations; partial discharge; synchronous measurement; ultrahigh frequency signal; Calibration; Charge measurement; Current measurement; Geographic Information Systems; IEC standards; Partial discharge measurement; Partial discharges; Substations; Switchgear; UHF measurements; Calibration; IEC 60270; gas-insulated switchgear (GIS); insulation diagnosis; partial discharge; ultra-high-frequency (UHF) method;

fLanguage

English

Journal_Title

Power Delivery, IEEE Transactions on

Publisher

ieee

ISSN

0885-8977

Type

jour

DOI

10.1109/TPWRD.2006.874655

Filename

1705554