Front-to-backside alignment using resist-patterned etch control and one etching step

A processing technique that aligns features on the front side of a wafer to those on its backside has been developed for bulk micromachining. A 30 μm-square and 1.6 μm-thick diaphragm serves as an alignment pattern. At the same time that the alignment diaphragm is made, much thicker, large-area diaphragms can be partially etched using `mesh´ masking patterns in these areas. The mesh-masking technique exploits the etch-rate differences between (100) and (111) planes to control the depths reached by etch pits in selected areas. The large partially etched diaphragms (2 to 3 mm², roughly 100 μm thick) are sufficiently robust to survive subsequent IC-processing steps in a silicon-foundry environment. The thin alignment diaphragm can be processed through these steps because of its very small area. The partially etched diaphragms can be reduced to useful thicknesses in a final etch step after the circuits have been fabricated