DocumentCode
808081
Title
Design of a Digital Loop for Numerical Control
Author
Koren, Yoram
Author_Institution
Faculty of Mechanical Engineering, Technion-Israel Institute of Technology, Haifa, Israel.
Issue
3
fYear
1978
Firstpage
212
Lastpage
217
Abstract
This paper describes a method for designing a digital loop for numerical control (NC) comprising an up-down counter, a digital-to-analog converter (DAC), a servo motor, and a digital encoder. The loop is analyzed and the open-loop gain is determined. The number of counter stages required for a given speed interval is also calculated. An example is presented to demonstrate the design procedure.
Keywords
Computer numerical control; Control systems; Counting circuits; DC motors; Design methodology; Frequency; Optical amplifiers; Optical pulses; Pulse amplifiers; Steady-state;
fLanguage
English
Journal_Title
Industrial Electronics and Control Instrumentation, IEEE Transactions on
Publisher
ieee
ISSN
0018-9421
Type
jour
DOI
10.1109/TIECI.1978.351554
Filename
4159394
Link To Document