Bicrystal YBCO DC SQUIDs with low noise

The authors have fabricated 12 DC superconducting quantum interference devices (SQUIDs) by laser-depositing YBa/sub 2/Cu/sub 3/O/sub 7-x/ on a SrTiO/sub 3/ bicrystal substrate with a misorientation angle of 24 degrees . At 77 K all 12 devices had acceptable values of critical current, resistance, and voltage modulation produced by an external magnetic field. The white noise energy of one device with an estimated inductance of 41 pH was 1.8*10/sup -30/ JHz/sup -1/. The noise power scaled as 1/f at frequencies below about 1 kHz; by using a bias current reversal scheme it was possible to reduce this noise by two orders of magnitude at 1 Hz, to a value of about 1.5*10/sup -29/ JHz/sup -1/. A magnetometer was made by coupling the SQUID to a flux transformer with a 5-turn input coil. The measured magnetic field gain was 60, and the white noise was 36 fT/ square root Hz. However, the transformer produced relatively large levels of 1/f flux noise, not reduced by the bias reversal scheme, that limited the noise at 1 Hz to 1.7 fT/ square root Hz. A single-layer magnetometer with a single-turn pick-up loop is described.<>