Theoretical and Experimental Investigation of the Ramp Losses in Conductor and Coil Casing of the ATLAS Barrel Toroid Coils

Each of the eight huge coils of the Barrel Toroid of the ATLAS detector consists of two double pancakes which are embedded in an aluminum alloy coil casing. The 57 mm times 12 mm sized conductor is a Rutherford cable with NbTi-Cu strands co-extruded with a high purity aluminum stabilizer. The race track coils have overall dimensions of 25 m times 5 m and the length of the conductor in the windings is 6.7 km. The coils are conduction cooled with forced flow helium. The nominal operating current is 20.5 kA and the nominal ramp rate is 4 A/s. During the test program of the individual coils the ramp losses are measured to confirm that they do not exceed the design cooling capacity of the ATLAS cryogenic system. The losses are determined from the amount of evaporated helium in the return flow. The ramp losses in the conductor consist of the hysteresis and coupling current losses in the Rutherford cable and eddy current loss in the pure aluminum stabilizer. Ohmic losses are generated in the coil casing which acts as a low resistive secondary of a transformer formed by the coil and the casing. In this paper the results of the loss measurements on the different coils, with different RRR (residual resistance ratio), are presented. Measurements are performed at various ramp rates. The results are in good agreement with the calculated losses, which are dominated by the loss in the coil casing