پديد آورندگان :
محمدي مقدم، تكتم نويسنده دانش‌آموخته دكتري مهندسي صنايع غذايي دانشگاه فردوسي مشهد Mohammadi Moghaddam, T , رضوي، سيدمحمدعلي نويسنده استاد گروه علوم و صنايع غذايي دانشگاه فردوسي مشهد Razavi, S. M. A , تقي زاده، مسعود نويسنده مركز تحقيقات كشاورزي پارس آباد مغان، اردبيل , , سازگارنيا، آمنه نويسنده دانشيار گروه فيزيك پزشكي دانشگاه علوم پزشكي مشهد Sazgarnia, A , پرادان، بيسواجت نويسنده University Putra Malaysia Pardhan, B
كليدواژه :
پسته , تصاوير ابر طيفي , آزمون فشاري , برشته كردن
چكيده لاتين :
Introduction: Pistachio nut is one of the most delicious and nutritious nuts in the world and it is being used as a salted and roasted product or as an ingredient in snacks, ice cream, desserts, etc. (Maghsudi, 2010; Kashaninejad et al. 2006). Roasting is one of the most important food processes which provides useful attributes to the product. One of the objectives of nut roasting is to alter and significantly enhance the flavor, texture, color and appearance of the product (Ozdemir, 2001). In recent years, spectral imaging techniques (i.e. hyperspectral and multispectral imaging) have emerged as powerful tools for safequality inspection of various agricultural commodities (Gowen et al., 2007). The objectives of this study were to apply reflectance hyperspectral imaging for non-destructive determination of moisture content and hardness of pistachio kernels roasted in different conditions.
Materials and methods: Dried O’hadi pistachio nuts were supplied from a local market in Mashhad. Pistachio nuts were soaked in 5L of 20% salt solution for 20min (Goktas Seyhan, 2003). For roasting process, three temperatures (90, 120 and 150°C), three times (20, 35 and 50 min) and three air velocities (0.5, 1.5 and 2.5 m s-1) were applied. The moisture content of pistachio kernels was measured in triplicate using oven drying (3 gr samples at 105 °C for 12 hours). Uniaxial compression test by a 35mm diameter plastic cylinder, was made on the pistachio kernels, which were mounted on a platform. Samples were compressed at a depth of 2mm and speed of 30 mm min-1. A hyperspectral imaging system in the Vis-NIR range (400-1000 nm) was employed. The spectral pre-processing techniques: first derivative and second derivative, median filter, Savitzkye-Golay, wavelet, multiplicative scatter correction (MSC) and standard normal variate transformation (SNV) were used. To make models at PLSR and ANN methods, ParLeS software and Matlab R2009a were used, respectively. The coefficient of determination (R2), the root mean square error of prediction (RMSEP) and the ratio of the standard deviation of the response variable to RMSEP (known as relative performance determinant (RPD)) were calculated.
Results and discussion:
Interpretation of hyperspectral data: The results showed that the spectra of the shell, the whole kernel and the internal part of the kernel have different patterns. The internal part of thekernel had 2 peaks at 630 nm and 690 nm, while the shell and the whole kernel had 1 peak at 670 nm and 720 nm, respectively and the peak of the whole kernel was sharper than that of the shell. The highest and lowest intensities were for the internal part of the kernel and the whole kernel, respectively. The spectral slope of the internal part is higher than that of the shell and the whole kernel at 500-700 nm.
The effect of different pre-processing techniques and analysis on prediction of pistachio kernels properties: In the absence of pre-processing techniques, low correlation coefficients were observed for prediction of moisture content and hardness. However, with the use of pre-processing techniques, in some models, correlation coefficient and RPD increased and the RMSEP decreased. The results revealed that ANN models would predict moisture content and textural characteristics of roasted pistachio kernels better than PLSR models.
Moisture content: ANN models can predict moisture content of roasted pistachio kernels better than PLSR models. In total, PLSR models showed low RPD and R2. For all samples, RPD was lower than 1.5, indicating that the developed models do not give an accurate prediction for moisture content. The best results with ANN method were achieved using a combination of SNV, wavelet and D1 for predicting moisture content with R2 =0.907 and RMSEP=0.179.
Hardness: The results indicated that ANN models can predict the hardness better than PLSR models. The best results with PLSR models were achieved using a combination of SNV, wavelet and D1 with R2= 0.643, RMSEP=10.78, RDP= 1.48 and 2 PLSR factors. However, due to high RMSEP and low R2 and RPD, it can be mentioned that prediction of hardness values with ANN model was not sufficiently desirable. However it was better than the PLSR models. The best results with ANN models were achieved using a combination of SNV, wavelet and D2 with R2=0.876 and RMSEP=5.216.
Conclusions: The results of this study showed that employing pre-processing methods causesa decrease in prediction error and improves the quality of the models. ANN models could predict moisture content and hardness of roasted pistachio kernels better than the PLSR models.
