شماره ركورد :
999826
عنوان مقاله :
استفاده از داده‌هاي GPS دوفركانسه و داده‌هاي ژئوفيزيكي درتعيين نرخ فعاليت زمين ساختي و شناسايي اثر قطعه دوم گسل كواترنري دورود (جنوب باختر ايران)
عنوان به زبان ديگر :
Using GPS RTK data and geophysical data in determine rate tectonics activity and identify trace second segment Dorud Quaternary fault (Southwestern Iran)
پديد آورندگان :
كمالي، زهرا دانشگاه بيرجند - گروه زمين شناسي , هيهات، محمودرضا دانشگاه بيرجند - گروه زمين شناسي , خطيب، محمدمهدي دانشگاه بيرجند - گروه زمين شناسي , نظري، حميد سازمان زمين شناسي و اكتشافات معدني كشور تهران - پژوهشكدة علوم زمين
تعداد صفحه :
15
از صفحه :
347
تا صفحه :
361
كليدواژه :
گسل جوان اصلي زاگرس , گسل دورود , GPS كنيماتيكي , مغناطيس سنجي سزيم
چكيده فارسي :
گسل دورود به عنوان يكي از مهم­ترين قطعات لرزه­زاي گسل اصلي جوان زاگرس از نزديكي منطقه ارجنگ در يك روند شمال‌باختري–جنوب‌خاوري تا بروجرد در طول امتداد يافته است. منطقه مورد بررسي بعنوان قطعه دوم از گسل دورود بين َ10 °33 تا َ25 °33 درجه عرض شمالي وَ05 °49 تا َ25 °49 درجه طول خاوري واقع شده است.در اين پژوهش بررسي‌هاي دقيق ريخت‌زمين‌ساختي به روش نزديك ميدان انجام گرفت و با انجام پيمايش به روش RTK توسط دستگاه GPS كينماتيك، مدل ارتفاعي رقومي و نقشه توپوگرافي رقومي با دقت بالا از سطح گسيختگي‌هاي تهيه شده، جابجايي‌هاي محاسبه شده براي 3 ايستگاه به ترتيب: جابجايي تجمعي افقي روي سطح گسل 21.59, 10.05, 13.94 جابجايي تجمعي قائم روي سطح گسل 58.6, 57.5 ,13.47 و جابجايي تجمعي خالص 22.88, 11.49 , 40/19 بدست آمد. به منظور بررسي سازوكار گسل زاويه ريك گسل محاسبه گرديد به ترتيب: °17،°29 و °44 است براساس نتايج بدست آمده گسل داراي مولفه شيب‌لغز مي‌باشد. همچنين در مطالعات ژئوفيزيك به روش مقاومت‌ويژه با آرايش دوقطبي(دايپل- دايپل) دو نيمرخ مورد استفاده قرار گرفت سپس پرداز نهايي و مدل‌سازي داده‌هاي مقاومت ويژه در نرم‌افزار Res2dinv انجام گرفت. در ادامه پيمايش مغناطيس‌سنجي سزيم بر روي 4 مقطع 160 متري صورت گرفت. پس از اتمام عمليات و برداشت داده‌ها و پردازش نهايي داده ها تفسير واضح‌تري از ساختارهاي زير‌سطحي به خصوص گسلش و ناپيوستگي در منطقه مورد مطالعه به دست آمد. گسل دورود در اين محدوده گسل 3شاخه بوده، كه گسل شاخه F4 به‌عنوان گسل اصلي دورود و مابقي شاخه‌هاي گسلي به موازات آن مي‌باشند.
چكيده لاتين :
The Zagros range extends for 1500 km from southeastern Turkey to Hormuz Strait and Persian Gulf. This active fold and thrust belt is composed of deformed sediments of the Arabian margin and has grown since Early-Middle Eocene in response to convergence and ongoing collision between Arabia and Eurasia plates. Crustal shortening in the Zagros is expressed by active folding and thrusting associated with a widely distributed shallow seismicity (depth < 20 km). The Dorud fault with general trend of NW-SE has known as one of the most important seismic in segments of Zagros Main Recent fault, near the Arjng area.In this study we use morphotectonic evidences to show that seismic behavior of this fault in the past has a clustering model in some time intervals. Geomorphic indicators are used as a tool to identify recent structures and movements. However, prior study of the region and the presence of high magnitude earthquakes that destroyed 100% of the villages with a 1 meter vertical displacement of the area indicate high tectonic activity. For this purpose at the first near-field morphotectonical analysis performed using Real Time Kinematics (RTK) GPS survey, digital elevation model and digital topographic map with high accuracy of surface ruptures of past earthquake prepared. To calculate the amount of displacement on the fault plane after applying the software steps on the DEM in Surfer software, perpendicular to the strike of the fault. These two lines extend the tangent to break the fault. The distance between the two points that cut two tangent lines indicates the amount of vertical displacement on the earth's surface. Digital elevation model and digital topographic map with high accuracy from the level of ruptures created from these findings were used to determine the quaternary fault of Dorud. Also, the geophysical studies of this part of the Dorud Fault after the preliminary studies of geology and the investigation of the probable extension of the fault using a special bipolar resistivity method (bipolar- bipolar) with a profile of 10 meters in 10 meters of two profiles were used. After the final processing and modeling the resilience data in Res2dinv software, the cesium magnetometric scanning was carried out on 4, 160-meter profiles. According the results calculated for 3 stations amounts displacement respectively: The horizontal cumulative displacement on the fault surface is 21.59, 10.05, and 13.94, the vertical displacement of the vertical side on the fault surface is calculated 58.6, 57.5 and 13.47 and the net cumulative displacement is measured 22.88, 11.49 and 40/19. In order to investigate the fault mechanisms, the rake angles were calculated of the fault respectively as 17, 29 and 44 degrees. According to the results, the fault has a dip- slip component. Geoelectric impressions using a bipolar and bipolar arrangement on 2 the highest for the apparent resistivity of 101.7 and the least value 7.2 mm. Geo-electric resistivity measurements with CRP arrangement with the characteristics of OA = 50m and MN = 20m included two profiles with 70 points and a total of 145 points. In order to determine the lateral changes of the ground resistance, CRP resistivity measurements with OA = 50m and MN = 20m profiles on 0 profiles containing 33 points and profiles 80 including 37 points were performed, the highest value for the specific strength of 135 the least value is 13 ohm-meter. Investigation was done by magnetization on four profiles of 0, 40, 80 and 100 consecutive (Continue) with linear 0.64m. Geophysical studies on faults Dorud, the resistivity data acquisition with dipole-dipole array and 10 and 10 meter electrode spacing. After final data processing and inversion of resistivity data in Res2dinv software, cesium magnetometery survey on 4 profiles 160 metric. After the completion of field operations and data question clearer interpretation of the subsurface structures, especially faults and discontinuities in the study area were obtained. The Dorud fault in this site is characterized by three fault lines, which is to say that the F'4 fault, according to morphotectonic studies, has been made as the main Drood fault and the rest as faults parallel to it.There are three possible fault symbols F'3, F'4 and F'5 in the region showed that there can be prepared a series of fault according to the geological map of the studied area is confirmed. The main fault as the fault F'4 Dorud and other faults are parallel to it. All branches of the fault are partly in parallel with stepped-up right and left Stairs in some places just to releasing bend small landslides were observed in the region and in the region just too restraining bend with compression strike- slip duplex.
سال انتشار :
1396
عنوان نشريه :
كواترنري ايران
فايل PDF :
7428129
عنوان نشريه :
كواترنري ايران
لينک به اين مدرک :
بازگشت