Pyrolysis as a technique for separating heavy metals from hyperaccumulators. Part II: Lab-scale pyrolysis of synthetic hyperaccumulator biomass

Synthetic hyperaccumulator biomass (SHB) impregnated with Ni, Zn, Cu, Co or Cr was used to conduct 11 experiments in a lab-scale fluidized bed reactor. Two runs with blank corn stover, with no metal added, were also conducted. The reactor was operated in an entrained mode in a oxygen-free (N2) environment at 873 K and 1 atm. The apparent gas residence time through the lab-scale reactor was 0.6 s at 873 K. The material balance for the lab-scale experiments on N2-free basis varied between 81% and 98%. The presence of a heavy metal in the SHB decreased the char yield and increased the tar yield, compared to the blank. The char and gas yields appeared to depend on the form of the metal salt used to prepare the SHB. However, the metal distribution in the product streams did not seem to be influenced by the chemical form of the metal salt used to prepare the SHB. Greater than 98.5% of the metal in the product stream was concentrated in the char formed by pyrolyzing and gasifying the SHB in the reactor. The metal concentration in the char varied between 0.7 and 15.3% depending on the type of metal in the SHB. However, the metal concentration was increased 4 to 6 times in the char compared to the feed.