شماره ركورد كنفرانس :
4561
عنوان مقاله :
Numerical and Experimental Measurement of Residual Stress in Vehicle Rim Using Incremental Hole-Drilling Method
Author/Authors :
E Ataei Department of Mechanical Engineering - Islamic Azad University of Sciences and Researches, Arak , H Khaki Department of Mechanical Engineering - Islamic Azad University of Sciences and Researches, Arak , A Nezamabadi Department of Mechanical Engineering - Islamic Azad University of Sciences and Researches, Arak
كليدواژه :
Residual Stress , Hole-Drilling Method , Calibration Coefficient , ASTM Standard , Software Analysis
عنوان كنفرانس :
The Bi-Annual International Conference on Experimental Solid Mechanics and Dynamics ۲۰۱۴
چكيده لاتين :
Residual stress is a kind of stress which remains in mechanical components even after removing external forces. Residual stress mainly happens during production process of a component which in result affects significantly its design and performance. The standard ASTM E837-01 analyzes residual stresses in components with flat surfaces using drilling method and presents stress calibration coefficients with constant stress profile. However, there is not any special standard to measure residual stress in curved component utilizing drilling method. In this study, the considered model which is a vehicle rim is simulated first; then a dynamic analysis is done under road load profile using ANSYS software and the critical points of the specimen are determined; in the next step, residual strain measurement test is performed using central drilling based on the standard; after calculating residual stresses experimentally, some suggestions are presented to reduce adverse residual stresses and enhance component’s life.
