Author/Authors
kahraman, funda mersin üniversitesi - tarsus teknoloji fakültesi - mekatronik mühendisliği bölümü, turkey , başar, gökhan osmaniye korkut ata üniversitesi - mühendislik fakültesi - imalat mühendisliği bölümü, Turkey , koçoğlu, zülfü mersin üniversitesi - fen bilimleri enstitüsü - imalat mühendisliği anabilim dalı, turkey , yeniyil, emre mersin üniversitesi - fen bilimleri enstitüsü - imalat mühendisliği anabilim dalı, turkey
Title Of Article
Optimization of Cutting Parameters in Hole Machining Process by Using Multi-objective Taguchi Approach
شماره ركورد
29427
Abstract
In this study, effects of drilling parameters on the various surface roughness characteristics; arithmetic average roughness (Ra), geometric average roughness (Rq) and average maximum height of the profile (Rz) in the wet drilling of AA 5754 Aluminium alloy were experimentally investigated. Cutting speed, feed and depth of cut were considered as control factors; Ra, Rz and Rq were considered as response factors. Experiments were designed according to Taguchi L9 orthogonal array. Varience analysis was performed to determine the importance of control factors on the surface roughness. The percent contributions of the control factors on the surface roughness were obtained to be feed (71.32%) and cutting speed (22.20%). Minimum surface roughness values Ra, Rz and Rq were obtained 120 m/min cutting speed, 0.10 mm/dev feed rate and 0.75 mm depth of cut by using multi-objective Taguchi approach.
From Page
283
NaturalLanguageKeyword
Aluminium , hole machining , surface roughness , Taguchi , optimization
JournalTitle
Journal Of Polytechnic
To Page
290
JournalTitle
Journal Of Polytechnic
Link To Document