Distance training of computer-based measurements and instrument control

Author

Gergic, Bojan

Author_Institution

Fac. of Electr. Eng. & Comput. Sci., Univ. of Maribor, Maribor, Slovenia

fYear

2014

fDate

3-5 April 2014

Firstpage

216

Lastpage

221

Abstract

This paper describes the distance training of computer-based measurements and instrument control for professionals from industry, which was performed within E-PRAGMATIC network (E-Learning and Practical Training of Mechatronics and Alternative Technologies in Industrial Community). The purpose of this training is to teach professionals from the industry the basics of data acquisition and instrument control using LabVIEW. The training contains hands-on exercises accessible through a remote workstation equipped with state of the art development software and measurement hardware.

Keywords

computer based training; data acquisition; distance learning; industrial engineering; mechatronics; virtual instrumentation; E-PRAGMATIC network; LabVIEW; computer-based measurements; data acquisition; development software; distance training; e-learning; industrial community; industrial training; instrument control; practical alternative technologies training; practical mechatronics training; remote laboratory; remote workstation; virtual instrumentation; Conferences; Cultural differences; Decision support systems; Engineering education; LabVIEW; e-learning; industrial training; remote laboratory; virtual instrumentation;

fLanguage

English

Publisher

ieee

Conference_Titel

Global Engineering Education Conference (EDUCON), 2014 IEEE

Conference_Location

Istanbul

Type

conf

DOI

10.1109/EDUCON.2014.6826094

Filename

6826094