DocumentCode
1540407
Title
Fabrication of ITER central solenoid model coil-outer module
Author
Ando, T. ; Hiyama, T. ; Takahashi, Y. ; Nakajima, H. ; Kato, T. ; Sugimoto, M. ; Isono, T. ; Kawano, K. ; Koizumi, N. ; Hamada, K. ; Nunoya, Y. ; Matsui, K. ; Ishio, K. ; Sawada, K. ; Azuma, K. ; Yamaoto, K. ; Kubo, H. ; Shiuba, T. ; Nishijima, G. ; Tsuch
Author_Institution
JAERI, Ibaraki, Japan
Volume
9
Issue
2
fYear
1999
fDate
6/1/1999 12:00:00 AM
Firstpage
628
Lastpage
631
Abstract
The central solenoid (CS) model coil-outer module being fabricated to demonstrate the justification of the CS design for the ITER, was almost completed except for epoxy impregnation to concrete whole layers. All the wound and heat treated layers have been assembled symmetrically with the insulation on the same axis, and for layer-to-layer joints the newly developed butt joint, has been installed.
Keywords
fusion reactor design; niobium alloys; superconducting coils; superconducting magnets; tin alloys; ITER central solenoid model coil-outer module; Nb/sub 3/Sn; Nb/sub 3/Sn strand strain; buffer zone; heat treatment; insulation structure; joint; tension line; Assembly; Concrete; Conductors; Fabrication; Heat treatment; Inductors; Insulation; Solenoids; Superconducting coils; Wounds;
fLanguage
English
Journal_Title
Applied Superconductivity, IEEE Transactions on
Publisher
ieee
ISSN
1051-8223
Type
jour
DOI
10.1109/77.783374
Filename
783374
Link To Document