DocumentCode
160835
Title
Influence of size of jig made of microstrip line for S-parameter method
Author
Yanagibashi, Taiga ; Sasamori, Takayuki ; Tobana, Teruo ; Isota, Yoji
Author_Institution
Fac. of Syst. Sci. & Technol., Akita Prefectural Univ., Akita, Japan
fYear
2014
fDate
4-6 Aug. 2014
Firstpage
203
Lastpage
204
Abstract
Recently, S-parameter method that is the measuring method of the input impedance of the balanced antenna with a vector network analyzer is proposed. It is a problem of this method that the jig influences measured value when the measuring frequency in-creases. To remove the influence of the jig, we have examined compensating method using the ABCD-matrix. In this report, we examine the effect of the size of the jig on the input impedance using the FDTD method. It is shown that the influence by the size of the jig is small.
Keywords
S-parameters; electric impedance measurement; finite difference time-domain analysis; fixtures; microstrip antennas; network analysers; ABCD-matrix; FDTD method; S-parameter method; balanced antenna; compensating method; finite difference time-domain method; jig; microstrip line; vector network analyzer; Antenna measurements; Dipole antennas; Frequency measurement; Impedance; Impedance measurement; Scattering parameters; S-parameter; balanced fed antenna;
fLanguage
English
Publisher
ieee
Conference_Titel
Electromagnetics (iWEM), 2014 IEEE International Workshop on
Conference_Location
Sapporo
Type
conf
DOI
10.1109/iWEM.2014.6963707
Filename
6963707
Link To Document