DocumentCode
1782074
Title
A novel S-bridged power plane with ultra wideband suppression of ground bounce noise using open stub
Author
Meng-Huan Lu ; Chen-Chao Wang ; Chih-Wen Kuo ; Kitazawa, Toshihide
Author_Institution
Dept. of Electr. Eng., Nat. Sun Yat-Sen Univ., Kaohsiung, Taiwan
fYear
2014
fDate
12-16 May 2014
Firstpage
330
Lastpage
333
Abstract
In this paper, a novel power plane is proposed using the novel S-shaped bridge electromagnetic bandgap (EBG) structure to isolate the ground bounce noise (GBN) and ultrawideband suppression of simultaneous switching noise (SSN) in high-speed circuit. The S-shaped bridge effectively increases the inductance between two adjacent unit cells. And the ripples are held down by open stub to get higher attenuation level. The stop-band of -30 dB suppression bandwidth of the design |S31| is from 114 MHz to 8.5 GHz, The results of simulation and experiment will be presented to verify the good performance, and that it covers the entire noise band.
Keywords
electromagnetic interference; interference suppression; photonic band gap; EBG structure; GBN; S-bridged power plane; S-shaped bridge electromagnetic bandgap structure; SSN; adjacent unit cells; attenuation level; bandwidth 114 MHz to 8.5 GHz; ground bounce noise; high-speed circuit; open stub; ripples; simultaneous switching noise; ultrawideband suppression; Inductance; Metamaterials; Noise; Periodic structures; Resonant frequency; Surface impedance; Ultra wideband technology; electromagnetic band-gap(EBG); ground bounce noise(GBN); high-speed circuit; open-stub; power-to-ground(PGN)plane; power/signal integrity;
fLanguage
English
Publisher
ieee
Conference_Titel
Electromagnetic Compatibility, Tokyo (EMC'14/Tokyo), 2014 International Symposium on
Conference_Location
Tokyo
Type
conf
Filename
6997135
Link To Document