Notice of RetractionFabrication of Anodic Aluminum Oxide (AAO) nano-porous membrane on both sides of aluminum sheet

Notice of Retraction

After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.

We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.

The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.

Fabrication of AAO Membrane is a time consuming and sensitive process. Several attempts have made to speed up this process. This paper reports the fabrication of AAO membrane at both sides of aluminum sheet. This method speeds up the fabrication process. This method of fabrication is easier because the aluminum sheet does not need to protect from the back side. This type of fabrication minimizes the total cost of nano-porous membrane. The fabrication of nano-porous membrane has been done by homemade system. The developed system can be used for mild anodization (MA), hard anodization (HA) and electro-polishing. This paper represents the fabrication of AAO membrane using 99.999% pure aluminum and commercial grade impure aluminum. The fabrication was done by MA and HA.