DocumentCode
2832895
Title
Improvement of laser trimmed film resistor stability by selection of optimal trim paths
Author
Ramirez-Angulo, Jaime ; Wang, Ruiting ; Geiger, Randall L.
Author_Institution
New Mexico State Univ., Las Cruces, NM, USA
fYear
1991
fDate
11-14 Jun 1991
Firstpage
2188
Abstract
A study comparing post-trim drift performance of laser-trimmed film resistors is presented. The goal was to determine the influence of the following factors on post-trim drift performance: (1) type of trim cuts, (2) initial trim position, (3) laser adjustment parameters, and (4) amount of trim. Based on these, simple design guidelines for improved resistor stability were derived. The study is based on computer simulations. Simple rules of thumb to optimally trim film resistors are derived. With these rules post-trim drift of film resistors can be reduced by as much as a factor four
Keywords
laser beam machining; stability; thin film resistors; computer simulations; laser adjustment parameters; laser trimmed film resistor stability; optimal trim paths; post-trim drift performance; Computer simulation; Fires; Guidelines; Home appliances; Laser beam cutting; Laser stability; Laser theory; Optical materials; Resistors; Temperature;
fLanguage
English
Publisher
ieee
Conference_Titel
Circuits and Systems, 1991., IEEE International Sympoisum on
Print_ISBN
0-7803-0050-5
Type
conf
DOI
10.1109/ISCAS.1991.176727
Filename
176727
Link To Document