Design of a Low Noise Amplifier of RF communication receiver for mine

Author

Su, Yu-na ; Li, Geng

Author_Institution

Coll. of Comput. Sci. & Technol., Henan Polytech. Univ., JiaoZuo, China

fYear

2012

fDate

24-27 June 2012

Firstpage

125

Lastpage

127

Abstract

The design ways and steps of a Low Noise Amplifier used in RF communication receiver for personnel orientation system in mine is been introduced in this paper. The key points are analysis device´s stability with Stability coefficient of determination of the ADS software and the input and output impedance matching with Smith Chart and Tuning. Finally, the performance parameters of LNA were obtained with the simulation of S parameters. The final simulation results show that the Use of ADS for low noise amplifier design is useful and has a good reference value for practical amplifier design.

Keywords

coal; electronic engineering computing; impedance matching; low noise amplifiers; mining; radio receivers; tuning; ADS software determination; RF communication receiver; S parameters; Smith chart; input and output impedance matching; low noise amplifier design; mine; performance LNA parameters; personnel orientation system; stability coefficient; tuning; Impedance matching; Software; ADS software; low noise amplifier (LNA); noise figure; optimization design;

fLanguage

English

Publisher

ieee

Conference_Titel

Electrical & Electronics Engineering (EEESYM), 2012 IEEE Symposium on

Conference_Location

Kuala Lumpur

Print_ISBN

978-1-4673-2363-5

Type

conf

DOI

10.1109/EEESym.2012.6258604

Filename

6258604