DocumentCode :
3283021
Title :
A low-loss MEMS tunable capacitor with movable dielectric
Author :
Zhu, Y. ; Yuce, M.R. ; Moheimani, S.O.R.
Author_Institution :
Sch. of Electr. Eng. & Comput. Sci., Univ. of Newcastle, Newcastle, NSW, Australia
fYear :
2009
fDate :
25-28 Oct. 2009
Firstpage :
651
Lastpage :
654
Abstract :
This paper reports a MEMS tunable capacitor with a new actuation principle. The new design adopts electrostatic actuation of an electrically floating movable dielectric. This enables us to achieve a high Q factor by eliminating the loss associated with springs in the RF signal path. Also, the design can achieve a high tuning range, by using additional actuation combs and thus eliminating the pull-in effect. Since no DC bias is applied on the plates of variable capacitor, the parallel plates 1/3 gap limitation does not apply. The designed devices were fabricated in a SOI MEMS process, with a 25 ¿m thick device layer and minimum gap of 2 ¿m. Measurement results show that the tunable capacitor has a 135 fF initial capacitance with a tuning range of 367% and a Q factor of 56 at 1 GHz by bidirectional actuation.
Keywords :
Q-factor; capacitors; electrostatic actuators; elemental semiconductors; micromechanical devices; silicon; silicon-on-insulator; tuning; Q factor; RF signal path; SOI MEMS process; Si; actuation combs; actuation principle; bidirectional actuation; electrically floating movable dielectric; electrostatic actuation; frequency 1 GHz; gap limitation; low-loss MEMS tunable capacitor; pull-in effect; size 25 mum; springs; tuning; Capacitance; Capacitors; Dielectrics; Drives; Micromechanical devices; Q factor; Springs; Tuning; Voltage; Voltage-controlled oscillators;
fLanguage :
English
Publisher :
ieee
Conference_Titel :
Sensors, 2009 IEEE
Conference_Location :
Christchurch
ISSN :
1930-0395
Print_ISBN :
978-1-4244-4548-6
Electronic_ISBN :
1930-0395
Type :
conf
DOI :
10.1109/ICSENS.2009.5398334
Filename :
5398334
Link To Document :
بازگشت