Voltage controlled SPMC with unity voltage conversion ratio and low total harmonic distortion

Author

Zin, M.F.M. ; Hamzah, N. ; Seroji, M.N.

Author_Institution

Fac. of Electr. Eng., Univ. Teknol. MARA, Shah Alam, Malaysia

fYear

2014

Firstpage

140

Lastpage

145

Abstract

This paper presents a closed-loop voltage controlled SPMC with the characteristic of unity voltage conversion ratio and low THD that comply the IEEE Standard 519-1992 and 1159-1995. The voltage controlled SPMC has a similar output voltage as compared to the input voltage which is 12Vac. The THD at the input and the output of the SPMC also reduced to below than 5%. The SPMC is controlled by a feedback control that measures the output voltage that has to be compared with the set point, Vref. This paper is based on the simulation done using MATLAB/Simulink. The results obtained are compared between opened-loop SPMC and the proposed closed-loop voltage controlled SPMC.

Keywords

IEEE standards; closed loop systems; harmonic distortion; matrix convertors; IEEE Standard 1159-1995; IEEE Standard 519-1992; THD; closed-loop voltage controlled SPMC; feedback control; single phase matrix converter; total harmonic distortion; unity voltage conversion ratio; Insulated gate bipolar transistors; Matrix converters; Passive filters; Power harmonic filters; Switches; Voltage control; Single Phase Matrix Converter (SPMC); Total Harmonic Distortion; Voltage Conversion Ratio;

fLanguage

English

Publisher

ieee

Conference_Titel

Electrical, Electronics and System Engineering (ICEESE), 2014 International Conference on

Type

conf

DOI

10.1109/ICEESE.2014.7154595

Filename

7154595