• DocumentCode
    3689553
  • Title

    Aspects of clamping a workpiece over a through hole

  • Author

    Attila Rétfalvi;Michael Stampfer

  • Author_Institution
    Subotica Tech/Department of Mechanical Engineering, Subotica, Serbia
  • fYear
    2015
  • Firstpage
    61
  • Lastpage
    66
  • Abstract
    This article analyzes those conditions that must be fulfilled so that a workpiece can be clamped over a through hole. By clamping a workpiece over a through hole the size of the required fixture can be reduced, and more surfaces can be machined in the same setup compared to other clamping solutions.
  • Keywords
    "Clamps","Fixtures","Finite element analysis","Planning","Force","Solid modeling","Fasteners"
  • Publisher
    ieee
  • Conference_Titel
    Intelligent Systems and Informatics (SISY), 2015 IEEE 13th International Symposium on
  • Type

    conf

  • DOI
    10.1109/SISY.2015.7325352
  • Filename
    7325352
    • Link To Document
    https://search.isc.ac/dl/search/defaultta.aspx?DTC=49&DC=3689553