Design study of 1MHz induction cavity for induction synchrotron

Author

Torikai, Kota ; Arakida, Yoshio ; Inagaki, Shigemi ; Koseki, Kunio ; Nakamura, Eiji ; Toyama, Takeshi ; Wake, Masayoshi ; Kishiro, Junichi ; Takayama, Ken ; Ishibashi, Kenji

Author_Institution

KEK, Tsukuba, Japan

Volume

3

fYear

2003

fDate

12-16 May 2003

Firstpage

1784

Abstract

An induction cavity was designed for the POP experiment of induction synchrotron using the KEK 12 GeV PS. It must be operated at a repetition rate of 667-882 kHz for acceleration from the injection energy to the flat-top energy. Design issues include handling of heat deposit, minimization of voltage droop and coupling impedance, and tolerable jitter. Its Q-value on the cavity assembled following the design was obtained from the longitudinal coupling impedance measurement. Effects of the droop in the acceleration voltage on the synchrotron motion, which has been estimated from the circuit parameter measurement on R, C, and L, was analysed from a longitudinal beam dynamics point of view. The effect of the droop is given by the square of phase delay.

Keywords

accelerator cavities; jitter; particle beam diagnostics; particle beam injection; synchrotrons; 12 GeV; 667 to 882 kHz; KEK 12 GeV PS; POP experiment; Q-value; acceleration voltage; circuit parameter measurement; flat-top energy; heat deposit; induction cavity; induction synchrotron; injection energy; longitudinal beam dynamics; longitudinal coupling impedance measurement; phase delay; repetition rate; synchrotron motion; tolerable jitter; voltage droop minimization; Acceleration; Accelerometers; Assembly; Coupling circuits; Impedance measurement; Jitter; Minimization; Motion analysis; Synchrotrons; Voltage;

fLanguage

English

Publisher

ieee

Conference_Titel

Particle Accelerator Conference, 2003. PAC 2003. Proceedings of the

ISSN

1063-3928

Print_ISBN

0-7803-7738-9

Type

conf

DOI

10.1109/PAC.2003.1288669

Filename

1288669