Full-wave investigation of EFT injection clamp calibration setup

Author

Caniggia, Spartaco ; Dudenhoeffer, Eric ; Maradei, Francescaromana

fYear

2010

fDate

25-30 July 2010

Firstpage

602

Lastpage

607

Abstract

The paper deals with a full-wave investigation of the capacitive coupling clamp that is used in electrical fast transient (EFT) immunity test to inject disturbances to nominal signals. The analysis is performed by using the software tool MicroWave Studio (MWS) based on the finite integration technique. The model of the injection clamp is validated by comparison with measurements and with the results obtained by SPICE. The full-wave model is used to investigate EFT injection clamp calibration setup, such as that proposed in section “6.4.2 Calibration of the capacitive coupling clamp” of the IEC 61000-4-4 new Edition (i.e., the 3rd).

Keywords

IEC standards; SPICE; calibration; transients; EFT injection clamp calibration setup; IEC 61000-4-4; MicroWave Studio; SPICE; capacitive coupling clamp; electrical fast transient immunity test; finite integration technique; full-wave investigation; full-wave model; software tool; Cable shielding; Calibration; Clamps; Couplings; Integrated circuit modeling; Load modeling; SPICE; Electrical Fast Transient/burst (EFT/B); Microwave Studio; SPICE; finite integration technique (FIT); full-wave analysis; immunity;

fLanguage

English

Publisher

ieee

Conference_Titel

Electromagnetic Compatibility (EMC), 2010 IEEE International Symposium on

Conference_Location

Fort Lauderdale, FL

ISSN

2158-110X

Print_ISBN

978-1-4244-6305-3

Type

conf

DOI

10.1109/ISEMC.2010.5711345

Filename

5711345