Attenuation of the parasitic modes in a shielded microstrip line by coating resistive films on the substrate

Author

Chou, Young-Hoang ; Chung, Shyh-Jong

Author_Institution

Inst. of Commun. Eng., Nat. Chiao Tung Univ., Hsinchu, Taiwan

Volume

43

Issue

7

fYear

1995

fDate

7/1/1995 12:00:00 AM

Firstpage

1610

Lastpage

1613

Abstract

In this paper, propagation characteristics of even-symmetric hybrid modes in a waveguide-shielded microstrip line with the presence of the resistive films affixed to the two sides of the center strip is investigated. The method of lines with modifications concerning the inhomogeneity of the surface between the air and substrate layers is used for analysis. After a validity check of the analysis by considering two special structures, i.e., a microstrip line (R_m=∞) and a coplanar waveguide (R_m=0), the resistance R_m and the width W_m of the film are varied to see the influence on the propagation and attenuation constants of the dominant mode as well as the higher-order (parasitic) modes. Optimal combinations of the resistance and the width are found so that the resistive film has the largest attenuating effect on the higher-order modes but has no interference with the dominant one

Keywords

electric resistance; electromagnetic shielding; microstrip lines; transmission line theory; attenuation constants; even-symmetric hybrid modes; higher-order modes; method of lines; parasitic modes attenuation; propagation characteristics; propagation constants; resistance; resistive film coating; shielded microstrip line; substrate coating; waveguide shielding; Artificial intelligence; Attenuation; Coatings; Coupling circuits; Cutoff frequency; Dielectric substrates; Electromagnetic waveguides; Microstrip; Packaging; Proximity effect;

fLanguage

English

Journal_Title

Microwave Theory and Techniques, IEEE Transactions on

Publisher

ieee

ISSN

0018-9480

Type

jour

DOI

10.1109/22.392924

Filename

392924