• DocumentCode
    839797
  • Title

    On tone-burst measurements of sound speed and attenuation in sandy marine sediments

  • Author

    Buckingham, Michael J. ; Richardson, Michael D.

  • Author_Institution
    Scripps Inst. of Technol., California Univ., San Diego, La Jolla, CA, USA
  • Volume
    27
  • Issue
    3
  • fYear
    2002
  • fDate
    7/1/2002 12:00:00 AM
  • Firstpage
    429
  • Lastpage
    453
  • Abstract
    During the Sediment Acoustics Experiment in 1999 (SAX99), the in Situ Sediment geoAcoustic Measurement System (ISSAMS), transmitting tone bursts containing an integer number of cycles, was used to measure the speed and attenuation of compressional waves in a weakly dispersive, medium-sand sediment in the Gulf of Mexico. ISSAMS was deployed at seven stations and operated mostly at a frequency of 38 kHz, but at two of the sites, a succession of pulses was transmitted with frequencies extending from 25 to 100 kHz, in 5-kHz increments, yielding the phase speed, the group speed and the attenuation as a function of frequency. An analysis of a tone-burst transmission in a dispersive medium illustrates that several subtle factors, including the narrow bandwidth of the source, along with dispersion and attenuation in the medium, have the potential for introducing significant errors into travel-time measurements. It is concluded that, in general, the timing is best performed between two receivers rather than between the source and a receiver, the difficulty in the latter case being that the output from a narrow-band source is not a replica of the input. A correlation applied to the arrivals at the two receivers yields the travel time, from which a good approximation to the group speed is immediately available. Alternatively, a Fourier decomposition yields the phase speed as a function of frequency, which would be an advantage in a highly dispersive medium. The two techniques return almost identical wave speeds when applied to the ISSAMS tone-burst data from the weakly dispersive SAX99 sediments: at 38 kHz, the mean wave speed from the six primary stations is 1778 m/s. Attenuation was also estimated from receiver-to-receiver travel paths, using three different techniques: the ratio of the mean-square values of the arrivals, the ratio of the Fourier magnitudes of the arrivals and transposition. All three methods yield similar results when applied to the SAX99 data, returning a mean attenuation from the six stations of 12 dB/m at 38 kHz, which is comparable with previously reported measurements of attenuation in marine sands. From the broadband measurements, between 25 and 100 kHz, the dispersion is found to be weak but detectable and the attenuation scales almost linearl- y with frequency, which corresponds to a nearly constant Q.
  • Keywords
    acoustic wave absorption; acoustic wave velocity measurement; oceanographic techniques; sand; sediments; underwater acoustic propagation; 25 to 100 kHz; 38 kHz; Fourier decomposition; SAX99 experiment; acoustic propagation; dispersive medium; in situ sediment geoacoustic measurement system; narrow-band source; sandy marine sediment; sound attenuation; sound speed; tone-burst measurement; travel-time measurement; Acoustic measurements; Acoustic waves; Attenuation measurement; Bandwidth; Dispersion; Frequency; Narrowband; Sediments; Timing; Velocity measurement;
  • fLanguage
    English
  • Journal_Title
    Oceanic Engineering, IEEE Journal of
  • Publisher
    ieee
  • ISSN
    0364-9059
  • Type

    jour

  • DOI
    10.1109/JOE.2002.1040929
  • Filename
    1040929