Experiments with small V-band waveguide reflector feeds

The radiation patterns of simple rectangular waveguide feeds have been measured at V band. A low-cost test arrangement, operating in the far field but without any absorbers, is shown to give better than 0.5 dB repeatability and more than 30 dB of dynamic range. The general rules of waveguide-feed design for reflector antennas are applicable, but the tendency of narrow feed patterns is somewhat emphasized compared to observations in earlier work at C or X band. For horizontal polarization, the difference is 5 dB at 90° between WR-28 and WR-90 hardware. This is partly caused by an increase in the relative guide material thickness at shorter wavelengths. No clear connection between pattern widths of the two linear polarizations was observed if the guide height was increased, the largest momentary deviation being 3 dB for a rectangular 7.1 by 7.1 millimeter feed. Changes in the guide width had a monotone effect up to 3 dB at 90° offset. Very small feed aperture sizes, around λ/4 or less, did not show respective widening of 1 dB patterns, although such expected effects were visible at lower amplitude levels.