Comparison of the calculated and measured stability of a NbTi cable-in-conduit conductor

Calculated curves of cable-in-conduit conductor (CICC) energy stability margins vs. current are compared to experimental curves obtained at Oak Ridge National Laboratory for NbTi single triplex conductors. The conductors ranged in length from 1.8 m to 4.8 m, and had no imposed helium flow. The initiating heat pulse was applied for 16.7 ms over the entire conductor length. The calculated stability curves display the large decrease in energy margin from the low current and high energy margin "well-cooled" stability region, to the high current and low energy margin "ill-cooled" region that was determined experimentally. The calculated "limiting current" of 250 A (boundary between the ill-cooled and well-cooled regions) also agrees with experiment. The multi-valued stability margins measured for lengths of 3.1 and 3.8 m could not be obtained by the computer model. Excluding the multiple stabilities, the calculated margins are generally 30% lower than the experimental values. The decrease in energy margin in the ill-cooled region was found to be due to the low critical to operating temperature difference (2.2 K at 250 A). This prevents an initiating pulse in the ill-cooled region from being able to generate significant Joule heating without quenching, limiting the energy margin.<>